Filter
Top Products
15www.infinityvac.com
English
fe
f
f
g
h
i
k
j
Part Part No.
Motor Belt 1102-FP
Headlight Bulb 1088-FP
Foam and Felt Filters 1083-FP
HEPA Filter 1082-FP
Telescopic Wand 1121-FP
Detachable Handle 1119-FP
Super Stretch Hose 1120-FP
Upper Hose Holder 1086-FP
Crevice Tool 1084-FP
Upholstry/Dusting Brush
Pet Hair Power Brush 1097-FP
Low Reach Bare Floor Brush
To replace new Belt:
Slide one end of the new Belt over the
motor-driven shaft (e).
Slide second end of the Belt around
Brush Roll (f).
Partially insert the right end of the roller
into one side holder (g).
Partially insert the left end into the other
side holder (h).
Push both ends all the way into the side
holders at the same time.
Center Belt on motor-driven shaft; test
Brush Roll for easy turning.
Line up the 4 tabs on the Belt and Brush
Roll Cover with the slots on the Power
Nozzle (i); push into place.
Turn the three locking screws clockwise
(j) to tighten.
Cleaning the Pet Hair Power
Brush
Slide locking latch (k) forward.
Gently tilt brush housing upward to open.
IMPORTANT: DO NOT force; it will not
open all the way.
Remove debris from turbine wheel and air
passage.
Ordering Replacement Parts
To order additional parts and accessories,
go to www.infinityvac.com or call
1-888-668-9600.
Note: some parts may
be available at your local Infinity retailer.