Filter
Top Products
13www.infinityvac.com
English
2
1
2
34
1
2
3
a
b
Checking for Blockages
1 Detachable Handle:
Lock vacuum into upright position.
Remove Detachable Handle and Telescopic Wand;
disconnect the hose.
Check both openings on the Detachable Handle, hose,
and wand for clogs.
2 Dust Cup Air Duct:
Lock into upright position.
Remove Dust Cup Assembly and empty Dust Cup,
if necessary.
Disconnect the Super Stretch Hose.
Check Air Duct behind Dust Cup for clogs; clear before
replacing Dust Cup Assembly.
3 Intake Opening behind the Brush Roll:
Lock vacuum and lay flat.
Check opening behind the Brush Roll for clogs.
Clear the opening.
Clear the Brush Roll; use scissors to carefully cut
away threads, hair or other debris that might be
trapped in the bristles.
4 Nozzle Hose Connector:
Remove Dust Cup Assembly.
Lock vacuum, lay flat and turn over.
Use a Phillips Head screwdriver to:
a Remove 2 screws from the access port cover and remove.
b Remove 2 screws to release the Nozzle Hose.
Check Nozzle Hose for clogs.
Blockages may cause your vacuum to
overheat and shut down. If so, clear the
blockages, then follow the instructions
for Resetting the Motor Thermostat
on page 14.
WARNING: Never insert sharp
objects into any opening to clear an
obstruction.
IMPORTANT: Damages caused
while clearing or attempting to clear
blockages are not covered under
your product’s limited warranty.
Unplug the
vacuum before
checking for
blockages.
Reassemble all parts securely before
operating vacuum.