Ikelite C-Lite 8 Home Safety Product User Manual


  Open as PDF
of 2
 
BBUULLBB ##00004422..5588 RREEPPLLAACCEEMMEENNTT____________________________________________________________________________________________________
To access the bulb compartment, the battery holder
must be removed from the front lens assembly.
Depress the white-color release tab to unlock the
battery holder, and then rotate the battery holder
counter-clockwise slightly. A spring then pushes the
battery holder away from the front lens.
Make sure the bulb is cool. Tilt the front lens assembly
up to allow the bulb and heat sink (bulb holder) to drop
from the rear of the reflector. Place the new bulb IKE 8
CELL #0042.58 inside the heat sink (bulb holder) and
insert into the reflector opening.
In an emergency, use a common PR-size bulb
approximating 10V in place of the high-intensity
bulb #0042.58.
RREEMMOOUUNNTT BBAATTTTEERRYY HHOOLLDDEERR______________________________________________________________________________________________________
After replacing the bulb, snap the battery holder to
the front lens assembly as follows:
• On the battery holder, note the "HANDLE / SWITCH
& SLOT" reference on the side opposite from the white
release tab.
• Align the "HANDLE / SWITCH & SLOT" reference on
the battery holder with the open slot on the front lens
assembly.
• The tab guides on the battery holder must align with
the tabs on the front lens assembly.
• Press the battery holder into the front lens assembly,
and rotate the battery holder clockwise slightly to lock
the holder in place. The white release tab should then
lock the battery holder in place on the front lens
assembly.
33
O'ring
Bulb
Rubber
Shroud
Heat
Sink
Slot
H
A
N
D
L
E
S
W
I
T
C
H
&
S
L
O
T
Tab Guide
Tab
Slot
MMAAIINNTTEENNAANNCCEE________________________________________________________________________________________________________________________________
1. We suggest storage of your lite with the locking lever OPEN to allow any potential hydrogen/air
mixture to escape.
2. The front edge of the lite body and the inner recess in the front assembly are the sealing
surfaces. DO NOT allow these surfaces to become damaged.
3. Keep the o-ring and sealing surfaces clean. DO NOT stretch the o-ring when cleaning. It is not
necessary to lubricate the o-ring. Never use spray lubricant because it will cause cracking of the
plastics.
4. Occasionally clean the metal contacts for a better connection.
5. The front head assembly has been factory sealed; DO NOT disassemble.
CCAAUUTTIIOONN____________________________________________________________________________________________________________________________________________
DO NOT use batteries that have been wet; batteries from a flooded lite should be discarded.
Water could create an internal short circuit at some later date causing a potential explosion. The
normal evolution of all batteries is emitting hydrogen gas. This gas must be absorbed or allowed to
escape to prevent ignition of the entrapped hydrogen/air mixture. We suggest storage of your lite
open to allow any hydrogen/air mixture to escape. A hydrogen absorber has been concealed inside
this lite and should NOT be removed. In case the lite floods, glue a new hydrogen absorber to the
back of the reflector and replace the batteries.
RREEPPLLAACCEEMMEENNTT PPAARRTTSS____________________________________________________________________________________________________________________
0042.58 C-Lite 8 BULB, IKE 8 CELL 10.4V halogen
0124 Main seal o-ring
0522 Rubber shroud
0836.32 Heat sink (bulb holder)
0910 Hydrogen absorber
9040.01 Battery holder assembly
9040.21 Front clear lens assembly with reflector and o-ring
LLIIMMIITTEEDD WWAARRRRAANNTTYY______________________________________________________________________________________________________________________
All Ikelite products are warranted against any manufacturing defects for a period of one year
from the date of purchase. Defective products should be returned prepaid to Ikelite. Ikelite will,
at its discretion, repair or replace such products, and will return to customer prepaid. All other
claims, of any nature, including but not limited to bulb failure are not covered. Except as men-
tioned above, no other warranty expressed or implied, applies to this Ikelite product.
IIKKEELLIITTEE UUNNDDEERRWWAATTEERR SSYYSSTTEEMMSS
50 West 33rd Street
PO Box 88100
Indianapolis, IN 46208 USA
317-923-4523
wwwwww..iikkeelliittee..ccoomm
Email ikelite@ikelite.com
1240-04-0707
 previous