Filter
Top Products
22
INSERTING THE BOBBIN
Attention: Turn power switch to off (“O”)
before inserting or removing the bobbin.
When inserting or removing the bobbin, the
needle must be fully raised.
1. Remove the bobbin cover and insert the
bobbin in the bobbin case with the thread
running in a counterclockwise direction
(arrow).
2. Pull the thread through the slit (A).
3. Pull the thread toward the left and along
the inside of the spring until it slips into
the notch (B) being sure that the thread
does not slip out of the slit (A).
4. Pull out about 15 cm (6 inches) of thread
and slide on the bobbin cover. (C)