Filter
Top Products
14
42834-01 • 01/27/10 • Hunter Fan Company
8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
8-14. To uninstall the light xture, rst disconnect the plug connectors
between the black wire and the black/white wire.
8-15. Disconnect the plug connectors between the two white
wires.
8-16. Uninstall the nut and washer from the end of the light
xture inside the lower switch housing.
8-17. Unscrew the threaded rod of the light xture from the lower
switch housing.
8-18. Remove the light xture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through rst, and then pull the other plug
connector (female) through the hole.
8-19. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
8-20. Install the switch housing cap and plug button to the lower
switch housing.
8-21. Once you have uninstalled the light xture, continue
with step 7-6.
Steps 8-16 – 8-18
Male Dummy
Terminal
Female Dummy
Terminal
Step 8-20
Cap
Plug Button
Lower Switch
Housing
readed Rod