Filter
Top Products
FORM 41505-01 Rev 6-12-2001 3 © 2001 HUNTER FAN CO.
Air Purifier Features
Electronic Key Pad Control
1. On/Speed Control: Press this button to turn the unit ‘on’. When you press it once, the
unit will be on low speed. Keep pressing the button to change speeds until you reach the
speed you desire.
2. Automatic Shut-off: If you desire the air purifier to shut off automatically, you can set
the timer. Press the timer button to choose the amount of time you would like the air
purifier to run (1, 2, 4, or 8 hours). Press the button repeatedly to change the length of time.
3. Ionizer: Press this button to turn ‘on’ the ionizer. When the ionizer is ‘on’, the green light
to the left of the button will be illuminated.
4. Check Filter: When the check filter light is illuminated, you should open the front grill and
compare the filter to the check filter chart. If the filter is dark, you should replace the filter.
5. Reset: When you change the filter, press the reset button. Use the tip of a pen or pencil to
press the reset button.
AIR PURIFIER PARTS
HEPAtech™ 377
FIGURE 1
RECESS FOR
FINGERS TO
PULL OPEN
FRONT GRILL
FRONT
GRILL
Remote Control
1. Controls: For your convenience, a remote control is pro-
vided with this air purifier. The remote may be used to turn
the air purifier on or off, adjust the fan speed, set the timer,
and turn the ionizer on or off. For function, use previous
instructions on how to control the Electronic Key Pad. To
use the remote, point it at the air purifier, then press and
release the appropriate key. The air purifier will beep once
to alert you that it has received the command and then it
will modify the appropriate setting. If the remote is not
working properly, first be sure that the remote is facing the
air purfier when pressing the key. If it still does not work,
check the batteries.
2. Batteries: Install two AAA batteries (UM-4 or IEC R03 or
Equivalent). Refer to the printed graphics in the battery
compartment for the proper orientation of the batteries.
OPEN
FIGURE 2