Filter
Top Products
OPERATION
1. Place the fan on a dry, safe, at
surface where it cannot fall or be
pulled by the cord.
2. Plug the fan into a 230-volt
AC electrical outlet (ordinary
household current). DO NOT use
any other type of outlet. Make sure
that the rated voltage of the fan
is the same as the power source
before plugging it into the power
source.
3. Turn the fan “ON” or “OFF” by sliding
the Power/Speed Control to the
right or left. The power should
always be OFF before unplugging
the fan.
4. To select the speed, move the
Power/Speed Control from OFF to
the desired speed setting: O (o), I
(low), II (medium), III (High).
5. To control the upward and
downward direction of airow,
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten the
screw.
6. To make the fan oscillate, push
44242-01 03/18/2009 5
FIGURE 3
Handle
Oscillation
Knob
Motor
Housing
Up/Down
Adjustment
Screw
Base
Power/Speed Control Switch
the oscillation knob down. To stop
oscillating, pull the oscillation knob
up. The oscillation knob is located
on the top of the fan housing, near
the handle. This appliance is for
household use only.