A SERVICE OF

logo

8
42856-01 • 01/30/09 • Hunter Fan Company
5-1. Place the fan housing over the motor.
5-2. Raise the trim ring to allow access to the holes on the
ceiling plate.
Note: Let the trim ring rest sitting diagonally on ceiling plate
to keep the trim ring out of the way while installing the
canopy screws.
5-3. Align the holes in the fan housing with the holes in the
ceiling plate.
5-4. Partially install each canopy screw into the holes in the
fan housing and into the ceiling plate until all holes are
aligned. Securely tighten all screws.
5-5. Lower the trim ring on the ceiling plate to cover the
canopy screws that were installed in the previous step.
Steps 5-1 – 5-3
Canopy Screw
Canopy
Screw
Ceiling Plate
Housing
5 • Installing the Motor Housing
Trim Ring
5 • Installing the Motor Housing