10
Hunter Fan Company 42819-01 • 11/14/06
Step Title
11
42819-01 • 11/14/06 Hunter Fan Company
7 • Completing Your Installation With or Without a Light Fixture
Your Hunter fan comes with an integrated light fi xture assembly and an
optional switch housing cap and plug button. is feature gives you the
option of installing the fan with OR without the included light fi xture.
e steps below direct you whether or not you are installing a light
fi xture.
WARNING: Use only the light fi xture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two housing
assembly screws into the switch housing mounting plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are fi rmly situated in the narrow end of the keyhole slots.
Install the remaining screw into the housing. Tighten all three
screws fi rmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fi xture falling.
7-5. If you want to install the light fi xture, proceed with step 7-6
now.
If you do not want to install the light fi xture, proceed with step
7-10 now.
Steps 7-1 – 7-3
Housing
Assembly
Screw
Upper
Switch
Housing
Step 7-4
7 • Completing Your
Installation With or
Without a Light Fixture
(Continued)
11
-6
emove t
e switc
ousing cap an
p
ug
utton.
-
.
he hole in the bottom on the lower switch housin
. Use the
ower switch housing. Securely tighten the nut and washer onto
-8
7-9
emove the wire nuts from the two wires from the lower switch
ousin
. Use one wire nut to connect the black wire
rom the li
ht
hite wire
rom the lower switch housin
AUTI
N
B
r
n
r
ir
r
ir
r
n
r
i
i
l
f
akin
connections
Light Fixture
ounting Scre
itc
s
n
i
As
ight Fixture
ounting Screw
