15
42753-01 • 09/12/30 • Hunter Fan Company
9 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
9-11. To uninstall the light xture, rst disconnect the plug connectors
between the black wire and the black/white wire.
9-12. Disconnect the plug connectors between the two white
wires.
9-13. Uninstall the connector and washer from the end of the
light xture inside the lower switch housing.
9-14. Unscrew the threaded rod of the light xture from the lower
switch housing.
9-15. Remove the light xture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through rst, and then pull the other plug
connector (female) through the hole.
9-16. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
9-17. Install the switch housing cap and plug button to the lower
switch housing.
9-18. Once you have uninstalled the light xture, continue
with step 9-6.
Lower Switch
Housing
readed Rod
Steps 9-13 – 9-15
Male Dummy
Terminal
Female Dummy
Terminal
Step 9-17
Cap
Plug Button
