WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angle mounting:
3-2. To assemble fan to hang down from a at or angled ceiling, insert
the downrod through the canopy. Feed the wires from the fan
through the downrod.
3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
3-4. Align and engage the two tabs from the bottom of the canopy
and the two grooves in the hanger ball. Skip to 3-9.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Prole mounting:
Note: For low prole mounting, the downrod is not used.
3-5. Remove the set screw from the adapter.
3-6. Using a sharp pointed tool, pierce three holes in the rubber gasket
where indicated by the holes in the housing.
3-7. Align the holes in the bottom of the canopy with the holes in the
motor housing and gasket.
3-8. Install three low prole screws to secure the canopy to the motor
housing.
Hanging the fan:
3-9. Raise the fan and place the hook on the ceiling plate through the
round hole in the rim.
Steps 3-1 – 3-2
Downrod
Canopy
Round
Hole
Step 3-9
3 • Assembling and Hanging the Fan
Set Screw
Adapter
Steps 3-7 – 3-8
Low Prole Screw
Canopy
Alignment
Hole
Motor
Housing
Low Prole Screw
