11
42620-01 • 11/09/09 • Hunter Fan Company
Plug
Connector
Detail
Housing
Assembly Screw
7 • Completing Your Installation With or Without a Multi Staked Light Fixture (Cont.)
Lower
Switch
Housing
Steps 7-6 – 7-7
Shade
Cup
Shade
Ring
Steps 7-9 – 7-10
Shade
Cup
Shade Ring
Glass Shade
Note: In compliance with U.S. Federal energy regulations, this
ceiling fan contains a wattage saver that restricts the light
kit to a maximum of 190 Watts. Exceeding that limit or
the specications on the light sockets may result in re
hazard or improper operation. If lights do not appear to be
operating properly, see the troubleshooting section
7-6. To attach the lower switch housing, connect the upper
plug connector from the motor to the lower plug
connector in the lower switch housing assembly.
Note: Both plug connectors are polarized and will only
t together one way. Make sure the connectors are
properly aligned before connecting them. Incorrect
connection could cause improper operation and
damage to the product.
7-7. Place the lower switch housing assembly over the upper
switch housing. Align the side screw holes in the upper
and lower switch housings. Attach the lower switch
housing to the upper switch housing with three housing
assembly screws.
7-8. Remove the shade ring from each shade cup.
7-9. Install each glass shade in a shade cup.
7-10. Install and tighten the shade ring to secure the glass
shade. Do not overtighten.
7-11. install candelabra bulbs (60 Watt Maximum) into the
sockets.
