Filter
Top Products
©2008 Hunter Fan Co. 41785 Rev 05-06-2008
6
6. Soak the Upper Reservoir, Funnel Pump, Pump Cap, and
Atomizer in a solution of one (1) gallon of water and eight (8)
ounces of vinegar for 30 minutes.
NOTE: If the Atomizer is covered with hard white scale, you
may want to run this component through the dishwasher to
loosen the scale before soaking.
The Atomizer is the only dishwasher-safe component and
may be placed in the top rack only.
7. To clean the Water Tank, fill the tank with one (1) gallon of
water and eight (8) ounces of vinegar. Replace the Tank Cap
tightly and shake the Water Tank vigorously until all interior
surfaces have been exposed to the solution.
8. Rinse the Water Tank several times with cool, clean water.
9. After soaking, rinse the components with clean water several
times. Use a soft cloth or sponge to remove any build-up.
Allow the components to dry completely if you plan to store
the humidifier.
10. To clean the surfaces of the Power Pack, wipe with a dry,
soft cloth.
Atomizer
Upper Reservoir
Funnel
Pump
Pump Cap
4. Remove the Pump Cap from the Funnel Pump by holding the
Pump Cap securely in one hand while twisting the Funnel
Pump in a clockwise direction. This will unlock the two
components. See Figures 14a and 14b.
Figure 14a
Pump Cap
Power Pack
Funnel Pump
Tabs
Fan Blade
Underside
Figure 14b
5. Remove the Atomizer and the Upper Reservoir. See Figure
15.
Figure 15
6. Soak the Upper Reservoir, Funnel Pump, Pump Cap, and
Atomizer in a solution of one (1) gallon of water and eight
(8) ounces of vinegar for 30 minutes.
Reassembly of Humidifier Parts
1. Set the Lower Reservoir on the flat, hard surface you have
chosen.
2. Attach the Upper Reservoir to the Lower Reservoir by
engaging the two tabs on the sides. See Figure 16.
Lower
Reservoir
Water Tank
Tank Cap
Upper Res-
ervoir
Tab
Atomizer
Power Pack
Figure 16