Filter
Top Products
41773-01 6
Operation
Initial Operation
This section provides basic instructions on the use of your air purifier. After following these
initial directions, please continue reading this booklet to learn how to operate the more
advanced features of your air purifier.
Basic Operation of the Air Purifier:
1. Take the air purifier out of the box and remove the clear plastic protective bag.
Place the unit on a firm level floor.
2. Before turning on the air purifier, you need to confirm that the filters are firmly
in place and have not become loose during shipping. To check the filters, first
open the front grill. Release the front grill by placing your fingers behind the tabs
and pulling forward. Refer to Figs. 2 and 3 (pg. 4).
3. Next, check the HEPAtech
®
filter by pressing firmly on all four corners of the
filter to ensure that it is fully inserted into the filter opening.
4. The carbon pre-filter is mounted inside the front grill with hook tape. Confirm
that it properly covers the grill vents. You may notice a few black particles com-
ing off the pre-filter. Those particles are part of the odor-removing activated car-
bon and will be collected on the filter during use.
5. Place the front grill back onto the unit. First, line up the tabs on the bottom of
the grill with the openings on the purifier base and then push the top of the
grill forward until it is closed. Refer to Figs. 2 and 3 (pg. 4). NOTE: This unit
will not operate unless the grill is in the correct position.
6. Plug the unit into a 120V electrical outlet and press the UP key. The air puri-
fier will start with a low blower speed.
7. Use the UP/DOWN keys to adjust the blower speed to the desired level (0 = Off,
1 = Low, 2 = Medium, 3 = High). Refer to Fig. 5.