Hunter Fan 30117 Air Cleaner User Manual


 
5
®
ENGLISH
Cleaner and Filter Replacement
1. Clean the outside of the unit with a soft, damp cloth. The front grill can be removed
and cleaned in soapy water. Remove the pre-fi lter before cleaning the front grill.
2. At least every 90 days, replace the carbon pre-fi lter. This is necessary to main-
tain proper odor removing and overall fi ltration performance. If necessary, it can
be changed more often. Mark the new fi lter installation sticker included with the
new carbon pre-fi lter. Be sure to remove any plastic wrapping that may be on
the new fi lter before you place it in the Air Purifi er.
3. While replacing the pre-fi lter, you should view the condition of the QuietFlo
®
HEPA Filter. Compare the fi lter to the color coded chart that is on the inside of
the housing. If the fi lter matches the dark color on the chart, you should remove
the fi lter and replace it with a new fi lter. Mark the new fi lter installation sticker
included with the new QuietFlo
®
HEPA Filter. Depending on use and environ-
ment, the HEPA Filter should last one year.
4. If you notice a decrease in air output or an increase in noise, the HEPA Filter may
be clogged. Replace it with a new QuietFlo
®
HEPA Filter.
Replacement Filters
To obtain a replacement filter for your Air Purifier, call 1-800-4Hunter for
your nearest retailer or Hunter Customer Service at (US) 1-888-830-1326,
(Canada) 1-888-855-8300. Please be prepared to tell the operator the model
number of your Air Purifi er and the model number of the fi lter you need to re-
place. Visit our website at www.hunterfan.com.
Hunter Air Purifi er Model No.: 30095 30117 30119 30145 30214 30215
Pre-Filter Replacement Model No.: 30901 30901 30901 30901 30901 30901
HEPA Filter Replacement Model No.: 30936 30936 30936 30938 30940 30940
Electrical Cord Storage
For your convenience, Model 30145 has cord wrap posts for easy storage of the elec-
trical cord. The cord wrap posts are located on the back of the air purifi er in the bot-
tom corners.
When received, the cord wrap posts will be in the collapsed position. To extend the
cord wrap posts, simply twist approximately
1
8
of a rotation and gently pull outward.
The post will extend approximately 0.5 inches. (Refer to Figure 4.) Once extended,
simply wrap the cord around the two posts until the desired length is obtained.