Filter
Top Products
3
®
ENGLISH
©2005 Hunter Fan Company 41769-01 04/26/2005
Setting Up Your Air Purifi er
1. Remove your air purifi er from the box and take it out of the clear plastic protective bag.
2. Place your HEPAtech
®
Air Purifi er on a fi rm, fl at fl oor.
3. Before turning the Air Purifi er ‘on,’ open the front grill.
• For Models 30078 & 30079: To release the front grill, press the buttons on the
side until the front grill slides easily over the buttons. (Refer to Figure 1.)
• For Models 30212 & 30213: To release the front grill, place your fi ngers
behind the tabs and pull forward. (Refer to Figure 2.)
4. Next, check the HEPAtech
®
fi lter by pressing fi rmly on all four corners of the fi lter
to ensure that it is fully inserted into the fi lter opening.
5. The carbon pre-fi lter is mounted inside of the front grill with “hook” tape. Con-
fi rm that it covers the grill vents. (Refer to Figure 3.)
6. Place the fi lter installation reminder sticker on the inside edge of the front grill. Circle
the month and write the year of installation for the pre-fi lter and HEPAtech
®
fi lter.
7. Replace the fi lter and front grill. Be sure that the bottom grill tabs are in position
fi rst, and then push the top of the grill forward until it is closed. The unit is now
ready for normal operation. NOTE: This unit will not operate unless the door is
placed in the correct position.
8. Plug the unit into a 120V electrical outlet.
AIR PURIFIER PARTS