Filter
Top Products
©2008 Hunter Fan Co. 43051-01 20080814
5
Hunter Fan Web Site: Provides a convenient link to
www.hunterfan.com for technical support, ordering
information, and owner’s manual information.
(internet connection required)
Filter Life Counter: Filter life is critical to the proper
operation of your Personal Air Cleaner. The
SOLO
2
software is equipped with life counters to let
you know when your filter needs to be checked.
Every 2800 hours of running time your SOLO
2
software will flash amber on the Hunter Logo and
Check Filter button. The Hunter Logo on the front
of the SOLO
2
unit will also flash amber. Figure 2.
Hold the Filter Reset button on the back of the unit
in for 3 seconds to reset the filter counter and turn
off the amber LED or press the Filter Reset button
under Filter. Although filter life is dependant on your
environment, this will give you a good indication
of when you should check your filter. (See page 8
for filter ordering or click the “filter” button on your
software interface to order over the web.)
Computer Power Sync: Allows you to set your
SOLO
2
to turn on/off with your computer. When
selected, whenever your computer is started, the
SOLO
2
will start as well. Selecting again will require
you to start the unit either through the interface or
the touch controls on the product.
Sleep Mode ON/OFF: selecting this mode, the unit
will shut down when your windows system goes into
sleep mode and start back up when sleep mode is
cancelled. When selected again, the SOLO
2
will
continue to run even when windows is in sleep
mode.
My Air Time: Your Solo
2
Personal Air Cleaner
software gives you the ability to record “programs”
you can run at any given time. Click the My Air
Time button and choose Record from the drop
down panel. You may record a maximum of 24
hours running time. During this time frame, you may
move the fan slider freely to adjust output during
your recording session. When you have finished
your recording session, Select Record to end. Then
select the days of the week you wish the program to
run.
NOTE: While recording your programs, your My
Air Time button will be red and “Recording” will
show at the bottom of the interface. When your
unit is not recording a program but does have a
program active, that programs time frame will be
displayed at the bottom of the SOLO
2
interface
and your My Air Time button will be blue.
Example: You start recording your program at
5PM, change your speed to high at 7PM then
move the speed control down to low at 10PM.
At 11PM you end your program and select all
weekdays as your program cycle. Your SOLO
2
will come on during the week at 5PM and run till
11PM, adjust the fan speed to high at 7PM and
low at 10PM.
Time: Displays the current computer time.
NOTES: When any feature on the SOLO
2
is
active, that button on your computer’s interface
will be blue.
To close any features drop down panel, click the
triangle at the bottom of the drop down panel.
Features and Settings (Cont.)
ADJUSTING THE SOLO
2
Now that the SOLO
2
is functional, you will need to adjust
it to direct the air flow towards you. Holding the top of the
SOLO
2
, tilt the unit back or forth until you find the angle that
will provide the best comfort level. Figure 4.
Figure 4.