Filter
Top Products
41282-01 9-1-2001 4 ©2001 Hunter Fan Company
3. The filter comes to you installed in the correct position. Grasp the filter, and pull it for-
ward, up, and out of the unit. Remove the plastic wrapping and replace the filter in the
unit. The white HEPAtech™ filter material should be facing outward (towards you).
4. Before closing the front cover, check the placement of the foam pre-filter. It is installed
under clips in the front cover. This pre-filter is washable and should be washed gently in
cold, soapy water whenever you notice a build up of dust or lint. However, the prefilter
should be completely dry before you reassemble it to the unit. The pre-filter extends the
life of the HEPAtech™ system filter.
5. Close the front cover by once again pressing the buttons and allowing the front cover to
slip into place over the buttons. The unit is now ready for normal operation.
6. Plug the unit into a 120V electrical outlet.
7. Select a speed by sliding the speed selector to the appropriate location. The red power
light will be illuminated when you have selected a speed.
Models 30025, 30040 and 37025 Only:
8. Turn the ionizer ‘on’, by sliding the ionizer switch to the ‘on’ position. The green light
will be illuminated when the ionizer is ‘on’.
NOTE: The ionizer can release negative ions when the fan is not blowing. If it is used
consistenly without the fan, the dust particles that are attracted to the negative ions
may deposit on your walls and floors. To minimize these deposits, we recommend that you
use the ionizer only when the fan is blowing (when the unit is on LO, MED, or HI speed).
Cleaning And Filter Replacement
1. Every few weeks, you should open the front grill and view the condition of the HEPAtech™
System Filter. Compare the filter to the color coded chart that is on the inside of the
housing. If the filter matches the dark color on the chart, you should remove the filter and
replace it with a new filter. BE SURE TO REMOVE THE PLASTIC WRAPPING BE-
FORE PLACING THE NEW FILTER INTO THE AIR PURIFIER.
2. Clean the outside of the unit with a soft, damp cloth. The front grill can be removed and
cleaned in soapy water.
3. When you remove the front grill to clean it, you should also remove the pre-filter from
the front grill and gently wash it in soapy water. Washing the pre-filter can help extend
the life of your HEPAtech™ Filter.
4. Be sure the front grill and pre-filter are completely dry before you reassemble them
with the unit.
5. Models 30010, 30025, 37025 and 30040 use Filter #30915. No other filter or material
should be used unless approved by Hunter Fan Company.