Hotpoint 52TGW Burner User Manual


 
7
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Installation
c) Minimum regulation of the hob burners:
turn the tap to minimum;
remove the knob and adjust the regulation screw,
which is positioned in or next to the tap pin, until the
flame is small but steady.
! In the case of liquid gas, the regulation screw must
be screwed in to the
bottom.
check that the flame
does not turn off when
you turn the tap quickly
from high to low.
d) Regulating the primary
air of the burners:
The primary air of the
burners requires no regulation.
Adapting to different types of gas
In order to adapt the oven to a different type of gas
with respect to the gas for which it was manufactured
(indicated on the label), follow these simple steps:
a) Replacing the oven burner nozzle
open the oven door fully
pull out the sliding oven bottom
Pry the fixing tab “V” and remove the oven burner
Unscrew the oven burner nozzle using the socket
spanner for the nozzles “Z”, or a 7 mm socket
spanner, and replace it with a nozzle suited to the
new type of gas (see Table 1).
Take particular care handling the spark plug wires
and the thermocouple pipes.
Replace all the parts, following the steps described
above in the reverse order.
b) Minimum regulation of the gas oven burner with
thermostat:
light the burner as described in the paragraph “the
oven knob” of the instruction booklet.
turn the knob to Max for about 10 minutes and then
turn the knob to the Min setting;
remove the knob;
regulate the screw positioned outside the thermostat
pin until the flame is small but steady.
! In the case of liquid gas, the regulation screw must
be screwed in to the bottom.
check that the burner does not turn off when you
turn the knob from Max to Min and and when you
open and close the oven door quickly.
Adapting the gas grill to different types of gas
Replacing the nozzle of the grill burner:
remove the screw and then slide out the grill burner
“V” (see Fig. E);
unscrew the grill burner nozzle using the special
socket spanner for the nozzles (see Fig. F) or better
still a 7 mm socket spanner; replace the nozzle with
a nozzle for the new type of gas (see table 1).
V
V
Z
unscrew the two screws and take off the shield
protecting the burner (in main oven burner only).