Filter
Top Products
10
Cyclonic Filter Assembly: How to Clean
4.9
4.10
Remove dirt cup as described in Fig. 4.3.
4.9 Twist filter assembly (A) counterclockwise.
Remove assembly from dirt cup.
4.10 Dirt and debris can be cleaned from the filter
assembly with the Dusting/ Upholstery Tool.
4.11 Place the filter assembly on the dirt cup,
aligning (3) tabs (A) on filter with (3) slots on dirt cup
(B) and twist it clockwise to secure into position.
Replace dirt cup as described in Fig. 4.5.
A
A
B
4.11
Carbon Filter: What to Buy
When used and maintained properly, your
Carbon filter should not need replacement
within the warranty period. If desired,
additional filter is available. Ask for Hoover
®
Part No.902404001.
Carbon Filter : How to Clean
(Available on select models only).
Your Carbon Filter is located under the Filter made
with HEPA media.
IMPORTANT
DO NOT RINSE OR WASH the Carbon Filter.
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place.
BRUSHROLL: How to Clean
4.12 Turn vacuum over so bottom side is facing up.
Rotate red upper latch (A) counterclockwise.
4.13 Slide red lower latch (B) to the unlock position.
4.14 Pivot out bottom plate and remove any debris
and/or hair from brushroll.
Reposition bottom plate, aligning tabs along front
edge of nozzle guard with slots in nozzle. Rotate
back into position. Slide red lower latch to Lock
position, and rotate red upper latch clockwise.
4.12
4.13
A
B
4.14
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.