Filter
Top Products
1-6
2. How to use
Cleaner description
18. Wands
19. Crevice tool
20. Cord hooks: wrap cord
around hooks for storage. Top
hook can be rotated right or
left for easy cord release.
21. Handle release pedal:
step on lever to lower handle
to operating or low positions.
Operate cleaner only at
voltage specified on data
plate on back of cleaner.
This cleaner is intended for
household use.
1. Handle grip
2. ON/OFF switch
3. Telescoping handle
4. Handle release button
5. Carrying handle
6. Dirt cup release button
7. Dirt cup assembly
8. Dirt cup door hinge
9. Stair cleaning handle:
located below lower edge
of dirt cup.
10. Headlight
11. Nozzle control knob:
turn knob to correct setting
for height of carpet being
cleaned.
12. Furniture guard: helps
prevent cleaner from mark-
ing furniture.
13. Hose handle
14.Combination tool
15. Powered hand tool
16. Hose
17. Hose/tool holder
ON-OFF switch
Plug cord into electrical outlet.
To turn cleaner ON, push ON/OFF
switch once.
To turn cleaner OFF, push switch
again.
1
18
13
17
15
12
A
20
20
19
8
16
A
B
D
C
3
2
15
6
7
10
9
4
5
11
14
14
21
4
Polarized plug
To reduce the risk of electric shock,
this appliance has a polarized plug
(one blade is wider than the other).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper out-
let. Do not change the plug in any
way.
2-1
Transporting cleaner
To move your cleaner from room to
room, put handle in upright position,
tilt cleaner back on rear wheels and
push forward.
2-3
2-2
Telescoping handle
For convenience in storing or carry-
ing your cleaner, the handle is
designed to retract into the body of
the cleaner. Lower the handle by
depressing the button (A) located at
the handle base and pushing the
handle down. Raise the handle by
depressing the button and pulling
the handle upward, locking it into
the desired position.
Position tools
Place smaller diameter end of wand
(A) into bottom of rack. Snap wand
into clip at top. Repeat with other
wand.
Crevice tool (B) fits into one of the
extension wands.
Snap combination tool (C) and pow-
ered hand tool (D) into storage
areas on back of cleaner as shown.