Filter
Top Products
5
Continued
➜
Carrying handle
Use the carrying handle to lift the
cleaner.
Transporting cleaner
Put handle in upright position. Tilt
cleaner back on rear wheels. Push
forward.
2-5
2-4
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
• Low setting: for all types of carpet and
hard floors.
Note: If the cleaner is difficult to push,
rotate knob to the next higher setting.
• Medium and High settings: for deeper
pile carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) as shown and will prevent
rug from clinging to cleaner. Continue to
lift up nozzle so that when you have
reached the edge, it is completely off
the rug. Move cleaner back to start
again, lower nozzle, and use only for-
ward strokes.
Carpet height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (B).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, turn
the carpet height adjustment knob (C) to
the desired setting.
For ease in turning the knob, place handle
in upright position and tilt cleaner back
slightly.
2-6
B
C
2-8 2-9
Stair cleaning
A stair cleaning handle has been
designed for ease in using your cleaner
on stairs. With handle in operating posi-
tion, place fingers under edge of stair
cleaning handle and guide cleaner with
other hand on upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the agita-
tor will continue to rotate.
CAUTION: To avoid personal injury or
unnecessary wear to carpet, and to
prevent the cleaner from falling,
always place it at the bottom of the
stairs.
2-7