Filter
Top Products
5
1-10
1 - 1 2
1 -1 3
1 -1 6
E
F
Attach lower hose
holder
With front of deep cleaner resting on
floor, place 2 projections (E) on lower
hose holder into 2 holes (F) on back of
cleaner.
Storing hose and
nozzle on rack
Stretch hose out and identify ends.
G. Nozzle connector end of hose
H. Solution tube
I. Trigger
J. Converter end of hose
Note: You may find it helpful when stor-
ing the hose and nozzle to refer to the
information on the back of the deep
cleaner and on the converter end of
the hose.
To store hose on rack, begin by placing
nozzle connector end of hose (K)
(straight end) into clip (L) on rack.
G
H
L
B
A
K
3
4
1
HOOK
L
2
I
J
1 - 1 4 1 - 1 5
Secure hose to rack at numbered loca-
tions as shown.
Converter is stored in area as shown.
While aligning arrows, place extension
into bottom of converter opening; then
push converter firmly against deep
cleaner until it snaps into place.
To remove, first pull top of converter off
extension then pull off bottom.
Secure solution hose to converter as
shown.
The nozzle is stored in the area between
the cord hooks.
Place brushes of nozzle on top of tab
(A) as shown. Gently push the nozzle
downward while pivoting it into the
nozzle holder (B).
Continued ➔
1-11
Push screw into hole and tighten
securely with a Phillips screwdriver.