Hoover SteamVac with Clean Surge Vacuum Cleaner User Manual


 
2-10
Rotate tank cap counterclockwise and
lift up to remove cap.
8
Agitator Speed
OFF
HI
LO
2-5
2-6
2-7
2-8
2-9
Automatic “shut off”
When the recovery tank (lower tank) is full
the automatic shutoff mechanism will shut
off the deep cleaner suction (suction will
be noticeably reduced).
At that time the yellow float disk will rise
to the top of the recovery tank lid (E).
The deep cleaner will no longer pick up
dirty solution and the motor sound will
become noticeably higher in pitch.
When this happens turn deep cleaner
off and empty recovery tank before
continuing use.
Check clean solution tank also; it may
need to be refilled.
E
F
G
Brush speed selector
Your ‘SteamVac’ deep cleaner has three
agitator brush settings.
Hl - for normal cleaning of carpet and
bare floors
LO - for gentle cleaning of carpets and
bare floors
OFF - for cleaning carpets and bare
floors when brushing is not desired.
(Such as when picking up liquid spills.
See page 11.)
Slide selector button to the desired set-
ting before cleaning.
Brush indicator
The brush indicator will spin (F) when
the deep cleaner is turned ON and the
brushes are rotating.
If the indicator does not spin and the
pattern is visible (G)
when the deep
cleaner is turned ON,
the brushes are
not rotating.
There are three reasons why the brushes
may not be rotating:
1. Brush speed selector set on OFF (see
previous section).
2. Handle in upright position.
3. Brush indicator screen dirty.
H
To clean screen (H), turn deep cleaner off
and disconnect from electrical outlet.
Remove clear cover and wipe off screen
with a damp cloth. Snap cover back into
position.
The tanks
Clean solution tank
(upper tank)
The clean solution tank holds the clean-
ing solution that is to be dispersed onto
the surface to be cleaned.
How to fill
Disconnect deep cleaner from
electrical outlet.
Place deep cleaner handle in the
upright, locked position.
To remove tank, press down on handle
and pull forward.
Carry tank to a sink.