Filter
Top Products
14
S t o r a g e
Before storing:
• Empty solution tank and rinse
thoroughly with clean water.
• Replace empty solution tank and
turn deep cleaner ON. Squeeze
trigger and push deep cleaner for-
ward and back several times to
expel any solution remaining in the
deep cleaner’s system. (Do not use
deep cleaner on wood floors.)
• Empty recovery tank and rinse
thoroughly with clean water.
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood surface.
Do not store deep cleaner with a full
solution tank in place.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication for
the life of the motor. The addition of lubri-
cant could cause damage. Do not add
lubricant to motor bearings.
4-2
2. Pull old bulb straight out of socket.
3. Push new bulb straight into socket until
locked into place.
Excessive fo rce is not required.
Reposition lens and secure with scre w.
4-3
4-4 4-5
A
B
B
B
B
Press handle release pedal to lower han-
dle. Turn cleaner over so bottom is fac-
ing up.
Grasp inner portion of brush (A) and pull
brush assembly out slightly to reveal
latches (B).
Press both latches (B) and pull brush
block out. The brushes can be cleaned
under running water.
To replace brushes
Align posts (C) on both ends of brush
assembly with slots (D) in cleaner hous-
ing.
Make sure that the square post (E) also
aligns with the square hole (F). Turn
brushes slightly until post fits easily into
hole.
Press brush firmly to snap into place.
4-6
4-7
C
C
D
D
E
F
Removable brushes
Your deep cleaner is equipped with
removable brushes for easy cleaning.
To remove brushes
Disconnect cleaner from electrical
outlet.
To prevent possible leaking, remove
clean solution tank and recovery tank.
Set tanks aside.