Filter
Top Products
Place a screwdriver under the belt as illus-
trated. Fig. 8.
8
Bracing the end of the screwdriver against
the end of the motor shaft, slide belt over
end of shaft. Fig. 9. Remove screwdriver.
Check to be sure belt is not twisted.
9
Rotate the agitator by hand to properly
align the belt on the motor shaft. Agitator
should rotate freely. Fig. 10.
IO
Replace agitator dirt seal. Place beveled
end toward front. Fig. 11.
11
Replace bottom plate by fitting the plate
over the lip at the front of the nozzle hous-
ing. Line up the slots over the wheels and
position holes in bottom plate over screw
mountings. Fig. 12. Replace screws.
12
13