Filter
Top Products
On certain types of dense carpet, it
may be advantageous to keep the
brush in a position where it does
not come in contact with the
carpet. To lock brush into the noz-
zle, adjust lever to “RUG” position
then press the brush all the way in-
to the nozzle with your finger.
While still holding the brush, adjust
the lever to the “FLOOR” position
and the brush will be locked into
place. To release brush; move the
brush lock lever either to the left or
right to the “RUG” position.
Note: Before using the nozzle on
hard surface floors, make certain
the brush is not locked into the
nozzle; then adjust the lever to the
“FLOOR” position.
For most efficient cleaning,
place the nozzle flat on rugs
and hard surface floors.
Edge cleaning feature
This feature provides for improved
cleaning of carpet edges near
baseboards and solid furniture.
Passages have been added to the
side of the nozzle to increase air
flow carrying dust from the carpet
edge to the nozzle.
Adjusting suction
The suction regulator is located on
the hose grip and may be used for
adjusting the amount of suction
when cleaning carpet and rugs or
when using the attachments.
Set the suction regulator to MINI-
MUM, MEDIUM, or MAXIMUM
suction by rotating the plastic ring
until the raised plastic indicator on
the dial is directly under the desired
setting.
8