Filter
Top Products
7
Align filter frame with separator frame
and press edges together.
3-8
3-6
3-7
Replace filter/separator assembly into
collector cup.
If soiled, wipe motor/handle section with
a damp cloth. Do not immerse in
water.
Reattach cup assembly to motor as
shown.
Hang cleaner back on wall bracket for
storage and recharging.
Battery recycling
Your cleaner contains nickel-cadmium
batteries.
When these batteries no longer
recharge, they must be removed from
the cleaner, recycled and disposed of
properly in accordance with state
laws as described in Item 3-14.
If you want to have a new battery pack
installed, contact your Hoover Factory
Service Center.
The following instructions are for dis-
assembly purposes ONLY.
3-9
How to remove battery
pack
Note: Do not remove the batteries to
recharge them. Follow the instructions
for charging the cleaner. The batteries
should only be removed if they no
longer recharge and you plan to dis-
pose of the cleaner.
Press latch and remove motor/handle
section of the cleaner from collector cup.
Cut data label (E) along seam on bottom
of motor/handle.
E
3-10
Unscrew the 4 Phillips head screws
on motor/handle section.
3-11
Separate motor/handle section halves.
(The motor assembly will remain in one
half of the housing.)
3-12
Pull motor assembly (F) from housing
(H). Remove only the tape that holds the
batteries (G) in place in the holder.
Do not remove label from the battery
pack.
F
G
H
3-13
Slide battery pack out of holders.
Disconnect the two wires from battery
terminals.
Dispose of battery pack in accordance
with your local and state laws. (See fol-
lowing page.)
Continued