Filter
Top Products
3-15
3-16
Drain solution tube by placing round
end in sink and raising nozzle above
your head. Press the trigger.
13
Drain suction hose by turning deep
cleaner ON and holding nozzle up for
several minutes. Do not press trigger.
Unplug deep cleaner from electrical
outlet.
Disconnect hose and solution tube
from deep cleaner.
Unplug deep cleaner from electrical
outlet.
1. Place handle in upright position and
remove hose from rack.
All tools attach to the hose in the same
manner:
2. Connect tool to hose by sliding it onto
connector until the tab (J) locks it
securely.
Using your thumb, push forward and
up on the latch (K) to remove tool.
G. SpinScrub™ hand tool has rotating
brushes for extra scrubbing action on
small carpet areas, carpeted stairs and
upholstery. For some models, the
brushes can be removed for converting
to the scrub module.
H. Stair/upholstery nozzle has a built-in
brush to help provide the scrubbing
action some spots may need for
removal.
I. Scrub module with detachable
scrub pad attaches to the base of the
SpinScrub™ hand tool (in place of brush
module). Can be used to scrub stub-
born areas such as scuff marks, dried
spills, and in hard to reach areas on
hard surfaces.
Select tool
Your model includes some combination
of the following tools, but may not
include them all.
3-13
How to attach tools
G
H
I
3-14
J
K
After using tool
The tool caddy can be removed and
hung on a coat hanger for storage.
Continued
➜
Attaching scrub module
Available at additional cost if not includ-
ed with your cleaner.
1. Open the tool door and remove the
SpinScrub™ hand tool.
2. Grasp the sides of the brush module
and lift it from the base (L).
3. Snap scrub module onto the base.
Note: If may be necessary to rotate the
scrub module (M) slightly so it will align
properly to the base.
3-17
L
M