Filter
Top Products
Instructions for Use
Wall Mounting
Your Hoover HandiVac comes with a specially designed bracket used to hold the recharging base so
that it may recharge while mounted on wall.
1. To mount the bracket, place it against the wall for the desired position, trace the mounting holes of
the bracket using a sharp pencil onto the wall or mounting surface. Make sure the wall bracket is
vertically positioned.
2. Drill a diameter hole into each of the marked holes. Insert a plastic anchor into each hole.
3. Drive one screw into the upper anchor leaving the screw slightly exposed.
4. Place the bracket on the exposed portion of screw, slide the bracket downward to let the screw
go into the slot.
5. Insert the second screw through the bracket into the lower anchor, tighten it to secure
the bracket.
NOTE: Care must be taken when drilling into walls.
NOTE: There are two different wall mount charging bases depending on your model purchased.