Hoover 53441 Vacuum Cleaner User Manual


 
Upright
Handle adjustments
The handle has three positions: Up-
right for storage and when using
attachments. Operating for general
operation on carpet and floors. Low
for reaching under low furniture.
Adjustment for carpet pile height
The cleaning of carpet and rugs takes
place at the nozzle. This is the opening
at the bottom of the cleaner where the
agitator is located.
It is necessary to raise and lower the
nozzle for various carpet pile heights.
The four positions are Low, Normal,
High and Shag.
Select the proper nozzle adjustment
by tilting the cleaner forward and
adjusting the lever until it “clicks”
into position.
For best results the lever is conven-
iently adjusted by hand.
Select the adjustment for the carpet pile height according to the chart below.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low
for low pile and kitchen carpet
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..*............
Normal
for rugs with normal pije height and for removing loose dirt from
hard surface floors.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..*.........................................
High
for rugs with normal pile height but thicker density; if the cleaner
is difficult to push at “Normal”, move the lever to the “High”
position
. . . . . . . . . . . . . . . .
..*..............................................................................*.......................
Shag
for very long or shag pile carpet
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
..*.....*.............................-...............................................
Note: If the “Low” setting is used when cleaning normal or shag pile carpet,
there is an increase in the belt load and pushing effort is greatly increased.
6
-