Filter
Top Products
VisionPRO
®
TH8000 Series
31
69-2400EFS—03
ENGLISH
In case of difficulty
Heating or
cooling system
does not respond
• Press SYSTEM to set system to Heat. Make sure the temperature is set higher than the
Inside temperature.
• Press SYSTEM to set system to Cool. Make sure the temperature is set lower than the
Inside temperature.
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• If “Wait” is displayed, the compressor protection timer is on. Wait
5 minutes for the system to restart safely, without damaging the
compressor (see page 15).
Display shows
Fan Auto and On
or Auto and Circ
at the same time
• This is normal operation. Auto indicates the thermostat is following the
programmed fan setting. If Auto and On is shown, the fan is scheduled
for “On” during this period (see page 7).