Filter
Top Products
–26–
✻
55 Enabling the 5842 Wireless Dialer
While in Program mode, press
✻55 to enter Wireless Dialer Programming Feature.
The following explains the
✻55 prompts in detail. The left two columns identify the prompts and list the
available entries for each. The right-most column provides a further explanation of the entries.
Note: You may find it convenient to adjust the volume setting before entering the Programming Mode. This will allow you to clearly
hear feedback announcements or system beeps.
Ed
Enable the wireless dialer
[✻] = continue
0 = disable
1 = enable
Enter [1] to enable the 5842 Wireless dialer. Press [✻] to advance to next
field.
Enter [0] to exit mode. The prompt “55” blinks, indicating the mode is
inactive. Press [
✻] + any field number to go to that field.
Er
Enable trouble reports
[✻] = continue
[#] = return to previous prompt
0 = disable
1 = enable
If selected, the following 5842 trouble reports will be enabled:
• Loss of RF link with 5842 Wireless Dialer
• Tamper at 5842
• Low Battery at 5842
• AC loss at 5842 (if supported by the specific wireless dialer being
installed)
• Line Cut at 5842 (if supported by the specific wireless dialer being
installed)
Enter [1] to enable 5842 Wireless Dialer trouble reports. Press [
✻] to
advance to next field or [#} to return to the previous prompt.
Ln
Response to phone line tamper
[✻] = continue
[#] = return to previous prompt
0 = enable trouble sounder
1 = enable alarm sounder
Select the Lynx response to detection of a line cut at the 5842 Wireless
Dialer.
If the trouble sounder is enabled the system will sound a trouble event any
time the 5842 phone line is cut.
If the alarm sounder is enabled the system will a trouble by day or an
alarm at night in the event that the 5842 phone line is cut.
Enter [1] to select alarm or [0] to select trouble in the event of a 5842 line
cut. Press [
✻] to advance to next field or [#} to return to the previous
prompt.
Note: If an X-10 device has been programmed to ZT05 or ZT07 and
*55 has been enabled, the device response will be dependent upon
the selection made in *55 Field "Ln".
Eb
Enable back-up reporting
[✻] = continue
[#] = return to previous prompt
0 = disable
1 = enable
Allows Lynx to do back-up reporting for the 5842 wireless dialer. Enter [1]
to enable back-up reporting. Refer to the 5842 Wireless Dialer Installation
guide for additional information.
Enter [0] to disable back-up reporting. Enter [#} to return to the previous
prompt.
Note: Lynx must be connected to the premises phone line via the 5842
Wireless Dialer.