Filter
Top Products
6
HZ-709/HZ-710 SERIES OPERATION (Continued)
STEP 4: SET TEMPERATURE
• You can set your desired temperature level in 1° increments anywhere from
45° to 85° F.
• To set your desired temperature, press the temperature button.
• When the display indicates your desired temperature, the display will revert
back to showing the current room temperature after 3 seconds.
• Once you have set your desired temperature the unit will operate under this
desired setting until the unit is turned o.
• When your desired room temperature has been reached your unit will shut o
and the house icon on the top of your display will illuminate (Fig. 9). It will
stay illuminated until the room temperature decreases below your desired
temperature level, at which time your unit will turn back on.
NOTE: If you wish to change your temperature setting or check to see what you set, simply press the temperature button once and
it will show you the set temperature. If you want to change it, continue to push the button up or down until you have reached your
new desired temperature. Again, after 3 seconds the display will revert to showing the current room temperature.
FAHRENHEIT/CELSIUS SETTING
This heater oers the option to read the temperature setting in either Fahrenheit or Celsius.
• The heater will default to the Fahrenheit setting when turned on.
• The heater can only be changed from Fahrenheit to Celsius when initially turned on.
• After turning the heater on the letter F will briey be displayed on the LED screen. While the F is displayed press the
temperature button down. At this point the letter “C” will be displayed and the heater temperature settings will be
displayed in Celsius.
NOTE: THIS HEATER WILL COOL DOWN SLOWLY AFTER THE POWER IS SHUT OFF. BEFORE MOVING THE HEATER, USING THE
BUILT IN HANDLE, ALLOW THE HEATER TO COOL.
Fig. 9
TIP-OVER SWITCH FEATURE (HZ-709/HZ-710 SERIES ONLY)
This heater is equipped with a tip-over switch that disables the heater if it is tipped sideward. To restore power to the heater:
• Place the heater in the upright position.
• Press the Power button.
• The LED display will activate and normal operation will resume.
TROUBLESHOOTING
If your heater shuts o unexpectedly:
• Be sure the heater is plugged in and that the electrical outlet is working.
• Check your temperature setting. The heater may simply be o because you
have reached your desired temperature setting or your timer setting may
have elapsed.
• Check to make sure your heater is assembled correctly. If your heater is
assembled and operating incorrectly it could result in a burning odor and
smoke (Fig. 10).
For more troubleshooting tips, visit our website at: www.kaz.com
Correct Incorrect
Fig. 10