Honeywell HZ-614 Air Conditioner User Manual


 
HZ-614, HZ-615, & HZ-617 SERIES OPERATION
Quick Heat
®
will propel a steady blast of warm air out of your baseboard. This can help heat your room
more quickly. You will hear a fan operating in this mode. You can also turn the Quick Heat
®
setting off
and the heater will operate silently.
QUICK HEAT
®
FEATURE
This heater is equipped with several devices and features for added
protection.
• A high temperature safety control prevents overheating
(Hi Limit).
• A back-up thermal circuit breaker that will permanently shut down
the heater should it operate at higher than normal temperatures
(HZ-614, HZ-615, HZ-617 and HZ-817 only).
• A SafeGuard
Alert Heat Indicator Badge that indicates the grille is
hot and should not be touched - turns from black to red (HZ-614C,
HZ-617, HZ-617C and HZ-817 only).
• Tip-over switch feature - The HZ-817 SERIES ONLY is equipped
with a tip-over switch that disables the heater if it is tipped over.
To restore power to the heater, stand the heater up properly and
press the power button.
• A three-prong grounded plug.
• This heater was created using a high quality safety plastic.
SAFETY FEATURES
15. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk
of fire. However, if you have to use an extension
cord, the cord shall be No. 14 AWG minimum
size and rated not less than 1875 watts. The
extension cord shall be a three wire cord with a
grounding-type cord and plug connector.
16. This heater draws 12.5 amps during operation.
To prevent overloading a circuit, do not plug
the heater into a circuit that already has other
appliances working.
17. It is normal for the plug to feel warm to the
touch; however, a loose fit between the
AC outlet (receptacle) and plug may cause
overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn
outlets.
18. Never tamper with this product or attempt to fix
it. Any tampering with, or modification of this
product can result in serious injury, death, fire
or risk of electric shock. Do not open, no user
serviceable parts inside.
19. Do not remove product labels that contain
warnings or safety instruction.
20. The output of this heater may vary and its
temperature may become intense enough
to burn exposed skin. Use of this heater is
not recommended for persons with reduced
sensitivity to heat or an inability to react to
avoid burns.
21
.
SAVE
THESE INSTRUCTIONS
• Place the heater on a firm, level surface away from any
combustible material.
• With Power knob in the OFF position, plug the heater into a
grounded outlet.
Turn the thermostat knob fully clockwise
to the high setting.
• To turn the heater on, turn the Power knob clockwise to the ON
position. (Fig. 2).
• If you want to use the Quick Heat
®
feature, turn the Power knob to
the Quick Heat
®
Setting.
When the room reaches a comfortable temperature, slowly turn the thermostat control counter-
clockwise
until the heater goes off. This is the point at which the thermostat setting equals the
room temperature. If left at this setting, the thermostat will automatically turn the heater on and off to
maintain the selected temperature.
• Place the heater on a firm, level, open surface free from
obstructions and at least 3 feet (0.9 m) away from any
combustible materials.
• Never leave an operating unit unattended.
• Plug the heater into an electrical wall outlet.
• Touch the power button to turn the heater on.
The power indicator light will illuminate. (Fig. 3)
• To save up to 35% in energy bills, turn the Energy Smart™
knob to your desired temperature. There are four distinct
settings of 65°F/18°C, 70°F/ 21°C, 75°F/23°C, and
80°F/26°C. The Energy Smart™ heater will automatically
select the appropriate power level to best accommodate
your desired temperature. As the air temperature in
the room approaches the set temp, the heater will
automatically lower the power consumption and provide
consistent warmth without wasting energy.
• The illuminated LED lights will indicate what the current room temperature is.
• This heater is equipped with a “frost watch” which automatically turns the unit on if the temperature
drops below 55°F/12°C degrees
• To override the Energy Smart™ feature and produce maximum heat, turn the knob fully clockwise to
“High”. This will produce 1500W of heat at all times.
HZ-817 SERIES OPERATION
Fig. 2
IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT
Fig. 1
Fig. 3
Power
Button
Quick
Heat
Power Indicator Light
Control
Knob
Fig. 4
Heat Indicator
Badge
Do not touch the grille until the
unit has been turned off and
the SafeGuard
Alert Badge has
turned back to black.
www.sylvane.com (800) 934-9194