Honeywell HZ-336 Electric Heater User Manual


 
3
OSCILLATION
REMOTE CONTROL OPERATION (HZ-336
SERIES):
Two (2) AAA batteries required.
Model HZ-336:
Remote Control included when originally pur-
chased.
Model: HZ-335:
Remote Control may be purchased separately at:
www.honeywellconumerproducts.com
The Remote Control works the same as the cor-
responding buttons on the Control Panel. The
Control Panel display on the heater will show the
appropriate icons when the various functions are
activated.
POWER:
MODE: SET TEMPERATURE
The Oscillation feature functions in any power or
mode setting.
Press the Oscillation button to toggle this feature on
and off.
High Power
Low Power
Press Power once to start the heater on High Power,
Continuous Run.
Press Power again to change to Low Power, Continu-
ous Run.
Press Power a third time to turn the heater off.
Power
Basic Remote
LCD Remote
Press Mode until the Temperature icon blinks. The
current room temperature will appear.
Use the Up or Down arrows to set the desired temper-
ature.
The Temperature icon will stop blinking and the current
room temperature will reappear after the desired tem-
perature is set.
The heater will turn-off shortly after the desired tem-
perature is reached and the Power light above the dis-
play will blink.
The heater will turn back on when the room tempera-
ture drops approximately 2 degrees below the desired
temperature. The Power light will stop blinking and will
remain lit.
Mode
Adjust Up or
Down
Set Temperature
Basic Remote
LCD Remote