Honeywell HZ-335 Electric Heater User Manual


 
2
BASIC CONTROL PANEL OPERATION:
POWER
MODE: SET TEMPERATURE
MODE: SET TIMER
FAHRENHEIT/CELSIUS
Continuous Run
High Power
Low Power
• Press Power once to start the heater on High Power,
Continuous Run.
• Press Power again to change to Low Power, Continuous
Run.
• Press Power a third time to turn the heater off.
Set Temperature
Press Mode until the Temperature icon blinks. The
current room temperature will appear.
Use the Up or Down arrows to set the desired tem-
perature.
The Temperature icon will stop blinking and the cur-
rent room temperature will reappear after the
desired temperature is set.
The heater will turn-off shortly after the desired tem-
perature is reached and the Power light above the
display will blink.
The heater will turn back on when the room temper-
ature drops approximately 2 degrees below the
desired temperature. The Power light will stop
blinking and will remain lit.
Timer
Press Mode until the Timer icon blinks. The Hour
display will appear.
Use the Up or Down arrows to set an operation time
between 1 and 10 hours.
The heater will turn-off when time runs out.
F/C Temperature
Display
F/C feature functions from only the Power or Set
Temperature screens.
Press the F/C button to toggle between Fahrenheit
and Celsius.