The Honeywell trademark is used by Kaz, Inc. under license from Honeywell Intellectual Properties, Inc.
IMPORTANT
SAFETY
INSTRUCTIONS
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. If
provided, use handle when moving this heater.
Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains
at least 3 feet (0.9 m) from the front of the
heater and keep them away from the sides and
rear.
3. Extreme caution is necessary when any heater
is used by or near children or invalids and
whenever the heater is left operating and
unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged
cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner.
Return heater to authorized service facility for
examination, electrical or mechanical
adjustment, or repair.
6. Do not use outdoors.
7. This heater is rated at 1500W, 120 VAC. It is
NOT intended for use on tabletops or
desktops, use
ONLY ON FLOORS. It is not to
be used in wet or moist locations, such as
bathrooms and laundry areas. If an extension
cord must be used, it must be 14 gauge or
larger and rated no less than 1875 watts.
8. Do not run cord under carpeting. Do not cover
cord with throw rugs, runners, or the like.
Arrange cord away from traffic area where it
will not be tripped over
.
9. This appliance has a polarized plug (one blade
is wider than the other). To reduce the risk of
shock, this plug is intended to fit only one way
in a polarized outlet. If the plug does not fit
securely in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.
DO
NOT
attempt to defeat this safety feature.
10. This heater draws 12.5 amps during operation
when in the high setting. To prevent
overloading a circuit, do not plug the heater
into a circuit that already has other appliances
working.
11. It is normal for the plug to feel warm to the
touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause
overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn
outlet.
12. To disconnect the heater, first turn controls to
the
OFF position, then grip the plug and pull it
from the wall outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the
heater.
14. To prevent a possible fire, do not block air
intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, where openings
may become blocked.
15. A heater has hot and arcing or sparking parts
inside. Do not use it in the areas where
gasoline, paint, or flammable liquids are used
or stored.
16. Use this heater only as described in this
manual. Any other use not recommended by
the manufacturer may cause fire, electric
shock, or injury to persons.
17. The output of this heater may vary and its
temperature may become intense enough to
burn exposed skin. Use of this heater is not
recommended for persons with reduced
sensitivity to heat or an inability to react to
avoid burns.
18.
SAVE THESE
INSTRUCTIONS
Tower Surround
Heater
Model HZ-3200 Series
Owner’s Manual
035-04027-000_R0 HZ-3200 OM 6/16/04 5:55 PM Page 1