Filter
Top Products
ATTACHING THE MANUAL CONTROL PANEL FOR ALL FANS
• Line up the three (3) tabs of the metal pole with the three (3) slots of the
Manual Control Panel and slide together, rotating it until it
locks (Fig. 4). The pole will no longer turn. Be sure to
tighten the knob on the back of the Manual Control Panel.
• At this point please insert the two (2) AAA batteries into
your remote control and slide it into the neck of the Manual
Control Panel.
COMPLETING THE ASSEMBLY
• Remove the Rear Grille Mounting Nut (D). Place the Rear Grille (E) onto the
Motor Housing by making sure the three (3) holes of the Rear Grille fit over the
three (3) bumps on the Motor Housing. Tighten the Rear Grille Mounting Nut
CLOCKWISE (Fig. 5).
• Push the Fan Blade onto the Motor Shaft, lining up the blade with the D-shape
on the Motor Shaft’s end. Tighten the Blade Knob (F) by turning it
COUNTER-CLOCKWISE (Fig. 6).
• Properly align the Front Grille and hook the top Grille clip (G) onto the Rear
Grille (Fig. 7).
• Fasten the built in clips around the Front Grille onto the Rear Grille (Fig. 8).
NOTE: The tilt angle of the Motor Assembly can be changed by simply tilting the
Motor up or down once the fan is completely assembled.
1
2
Fig. 4
Fig. 6Fig. 5
E
D
Fig. 7
G
Fig. 8
F
OPERATION
• Place your fan on a level and dry surface.
• Plug the power cord into a 120 Volt AC wall outlet.
• To turn fan on press the “ON/SPEED” button one time.
• When fan is on it will start in low speed. Press button again while on low speed
and fan will switch to medium speed. While on medium press “ON/SPEED”
button and fan will switch to high speed.
• When your fan is on high speed, pressing the “ON/SPEED” button will return
your fan to low speed.