Honeywell HCM-2051 Humidifier User Manual


 
Remove the water tank by grasping handle and
pulling straight up (Fig. 1). Set aside.
Lift up on the motor housing to remove and set aside
(Fig. 2). Remove the Natural Cool Moisture
®
filter
from the base before filling the unit with water. Soak
filter in a sink full of cool water to help reduce
mineral build up and place back in the humidifier
while wet. DO NOT SQUEEZE OR WRING OUT THE
NATURAL COOL MOISTURE
®
FILTER. To help extend
the life of your filter repeat this step each time you
fill your humidifier.
Turn the Water Tank upside down so that the Fill Cap
is facing up; unscrew the Fill Cap by turning it
counter-clockwise and set aside.
Fill the Water Tank with COOL tap water (Fig. 3).
Distilled water is not necessary as the water is filtered
by the Natural Cool Moisture
®
filter.
DO NOT USE HOT
WATER.
Doing so may damage the humidifier.
Replace the fill cap by turning it clockwise . DO
NOT OVER TIGHTEN. Turn the Water Tank right-side
up.
NOTE: WHEN CARRYING THE FILLED WATER TANK
PLEASE USE THE HANDLE AND PLACE YOUR OTHER
HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.
NOTE: We recommend that the humidifier be disinfected prior to first use. Please
see CLEANING instructions.
Select a firm, level, flat location - at least six inches from any wall for proper air flow (Fig.
1). Place the humidifier on a water-resistant surface, as water can damage furniture and
some flooring.
The manufacturer will not accept responsibility for property damage caused by water
spillage
Fig. 1
Fig. 2
Fig. 3
WALL
6"
SET UP
FILLING
HCM-2051 OM (eng only) 6/25/01 1:40 PM Page 4