Honeywell ANN-RLY Smoke Alarm User Manual


  Open as PDF
of 3
 
1
ANN-RLY Module Document # 53033 Rev. B 10/10/07 ECN 07-744
ANN-RLY Relay Module
Installation Instructions
The ANN-RLY relay module provides 10 program-
mable Form-C relays when used with a compatible
FACP (Fire Alarm Control Panel). This document
is provided as a quick reference. For more detailed
information, refer to the appropriate FACP installa-
tion manual.
Note: Installation and wiring of this device must be
done in accordance with NFPA 72 and local
ordinances.
Specifications
Mounting
The ANN-RLY module may be mounted inside the
FACP main circuit board chassis or in the battery
area of the enclosure using mounting bracket P/N:
ANN-MBRLY. Refer to the following illustrations
for installation information.
Note:
1. ANN-RLY module can be installed without
removing the main circuit board or chassis.
2. ANN-MBRLY mounting bracket must be used
for the MS-9200UDLS.
Table 1: ANN-RLY Module Specifications
ANN-RLY module
mounting slots
ANN-RLY module
mounting holes
chassis
ANN-RLY module standoffs
ANN-RLY module mounting hooks
R1 R3 R5 R7 R9
R2 R4 R6 (bottom) R8 R10
egatloVgnitarepOCDV42
@tnerruC.xaM
CDV42
mralAAm57
ybdnatSAm51
erutarepmeTgnitarepO
0
o
94ot
o
C
23(
o
021ot
o
)F
morfecnatsiDgniriW.xaM
)eriwGWA21htiw(PCAF
.tf052,1
)m083(
sgnitaRtcatnoCyaleRCDV03@spma2
)evitsiser(
CAV0
3@spma5.0
)evitsiser(
ylnOnoitacoLyrDniesUroodnI
1. Install the two supplied snap-in standoffs into the
backside of the ANN-RLY circuit board in
locations indicated in illustration above.
2. Using supplied hardware, attach the ground wire
using a screw and nut to location indicated in
illustration above. Be sure to position the ground
wire as shown to facilitate ANN-RLY installation.
3. Position the ANN-RLY module in the chassis so
that the two standoffs in the module are posi-
tioned over the wider portion of the mounting
holes in the chassis and the mounting hooks on
the module are sticking through the module
mounting slots in the bottom of the chassis.
4. Slide the ANN-RLY module to the right to lock
the module into place.
5. Attach the ground wire installed in step 2 to the
chassis in the location indicated below.
ground
wire
ground
wire
R1 R3 R5 (top) R7 R9
Mounting in FACP Main Board Chassis
next