Filter
Top Products
Models 5103 - 5108
Steel Security Safe with Digital Lock
PACKAGE CONTENTS
1 – Steel Security Safe
1 – Operation Manual
2 – Override Access Keys
4 – “AA” Batteries
1 – Mounting Kit w/ Bolts
DO NOT RETURN SAFE TO STORE!
If there are any missing parts or you have
difficulty setting up or operating your safe,
please contact our Consumer Assistance
Department by telephone:
1-877-354-5457
(USA & Canada)
Monday–Friday
7am - 5pm PST
PRODUCT OVERVIEW
A - LED Display panel
B - Safe Cabinet Body
C - Safe Door Assembly
D - Electronic Digital Keypad
E - Override Key Cover
F - Serial Number Label
IMPORTANT: Remove plastic corners from outside of safe door before operating.
SETUP & OPERATION
STEP 1. OPEN SAFE WITH OVERRIDE KEY
1. Remove plastic override key cover.
2. Insert override key and turn right to unlock safe.
3. Open safe door (key can not be removed when open).
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on inside door.
2. Insert 4 “AA” batteries (included).
3. Replace the battery cover.
4. Do not close door before testing digital lock.
STEP 3. TEST DIGITAL LOCK
1. With door open, turn key left to put door bolts (B) in lock position.
2. Remove override key and store in a secure place. Never store keys inside safe!
3. Enter the factory preset pass code: “1”-“5”–“9”
4. Immediately after entering the code, press the “lock” key.
5. Lock bolts should recede into the unlocked position.
STEP 4. LOCK SAFE WITH A NEW PASS CODE
1. Close the safe door and hold it closed.
2. Enter a new (3-6 digit) pass code followed by “lock”.
3. Motorized lock will return door to closed position.
4. The LED will display “CLOSED” for 3 seconds followed
by the active code entered as a reminder.
NOTE: The lock design allows for a new user code each time that the safe is locked
STEP 5. OPEN SAFE WITH NEW PASS CODE
1. To open safe enter the new pass code that was used to
lock the safe followed by “lock”.
2. The motorized lock will unlock the door and the LED will
display “OPENED”.
PRIVACY MODE:
To prevent the LED displaying the pass code entered, press “clear” prior to entering a code.