Filter
Top Products
6
The LifeTime HEPA
™
Filter is vacuum-able and should be cleaned regularly for optimum
performance.
To Clean the HEPA Filter:
• DO NOT USE WATER OR OTHER LIQUIDS TO CLEAN THE HEPA FILTER.
• Turn the air purifier OFF and unplug from the wall outlet.
• After removing the filter assembly from the air purifier (refer to section
“Removing/Changing the Filters” in this manual), separate and remove the carbon
pre-filter from the HEPA filter and place aside (or discard if pre-filter needs
replacement).
• To vacuum-clean the filter, hold the filter and run a vacuum cleaner with a nozzle or
brush attachment along the filter to pick-up the dirt and particles (Fig.4). Repeat along
the entire surface of the HEPA filter.
• Do not penetrate the HEPA paper pleats with the vacuum attachment since tearing or
puncturing can occur.
• Note that the filter may still be discolored even after
cleaning it. This is acceptable and will not affect
performance.
• After vacuuming the filter, wrap the pre-filter around
the HEPA filter and place the whole assembly back
into the internal chamber of the air purifier (see
“Removing/Changing the Filters”)
• You now need to reset the Intelli-Check
™
Filter
Indicator. With the air purifier powered on, press
and hold the appropriate filter indicator button for
approximately 10 seconds until the light turns off
(see Fig. 1).
If the HEPA filter clogs or if you have difficulty cleaning the filter, please visit us at
www.kaz.com or call us at 1-800-332-1110.
Fig 4
Cleaning the Lifetime HEPA
™
Permanent Filter*
*Permanent filter life based on ordinary use and care.
18155 OM Eng.qxd 7/21/05 1:34 PM Page 6