Filter
Top Products
76
Tr o u b l e s h o o t i n g
•If water of rainfall holes fail to flow:
Take off the lid and remove cleaning pin. Take cleaning pin
and stick through holes several times (Fig 5). When finished
snap cleaning pin into place and replace lid.
•If the pump fails to operate, check
the following:
Check the circuit breaker, or try a different outlet to make
sure the pump is getting electrical power. N O T E : Always
disconnect from electrical outlet before handling the pump.
•If the pump gurgles, spews, or “burps”:
Check the water level to make sure the pump has enough
water to function.
•Obtaining a desired water level:
Check the water level daily the first week to measure the rate
of evaporation; refill with water as needed.
•If water is splashing outside
the fountain:
Adjust the flow control valve to a lower setting on the pump.
M a i n t e n a n c e
• To keep water clean:
Periodically change water and clean the product according to the water
condition. Keeping the water clean prevents the water from becoming
sticky and forming micro-organisms. We recommend distilled water to
prevent mineral build-up.
• To clean off hard water deposits on
the base:
Clean the container in a mixture of vinegar and water to clean and
remove any mineral build-up.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level and to
avoid shortening the life of the pump. N O T E : Never let the pump run dry.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water,
and store in a dry, cool place. To store the provided cleaning pin
lift fountain lid and snap into clip (Fig. 4).
C a u t i o n :
All servicing of
this fountain
must be
performed by
a u t h o r i z e d
HoMedics
service
personnel only.
A t t e n t i o n :
In order to get
best results,
please operate
pump completely
s u b m e r g e d
Figure 4
Cleaning Pin
Figure 5
Cleaning Pin
Fountain Lid
WFL-RAIN 5/17/04 10:40 AM Page 7