Holmes HM1297 Humidifier User Manual


 
20.DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
21.Never place housing under water flow or immerse in
liquids.
22.Do not plug in the cord with wet hands: electric shock
could result.
23.Do not pour water in any openings other than the
water tank.
24.To prevent damage to surfaces, do not place
humidifier under overhanging surfaces.
25.NEVER operate unit without water in the tank.
26.Do not move unit after it has been used until unit
cools completely.
27.Use both hands when carrying full tank of water.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
Consumer Safety Information
NOTE: This is an electrical appliance and requires
attention when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has
plenty of humidity and additional moisture may cause
damage.
NOTE: DO NOT block air inlet or outlet.
Cord and Plug Installation Safety Instructions
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical rating
of the extension cord must be equal to or greater than the
rating of the humidifier (refer to the rating artwork
placed on the humidifier). Care must be taken to arrange
the extension cord so that it will not drape over the
countertop or tabletop where it can be pulled on by
children or accidentally tripped over.
HOW COOL MIST WORKS
Your Holmes
®
Cool Mist humidifier draws dry air through
the rear air intake grill area. This air is then passed
through a moisture–laden wick filter, which retains the
minerals and deposits in the water. The resulting moist air
is directed back into the room from the top air grill.
NOTE: This humidification system provides a cool,
invisible moisture output. It is normal not to see the mist.
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is
between 40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Select a location for your humidifier, on a flat surface,
about 4 inches (10 cm) away from the wall. Do not
place your humidifier on furniture; a floor location
that will not be damaged by moisture is best.
2. Remove the water tank by holding the tank handle
and lifting straight upward (see Figure 2).
3. Remove the main housing by lifting straight upward.
Check to see that the wick filter is properly in place.
Replace the humidifier housing.
FILLING THE WATER TANK
NOTE: The humidifier will produce up to 3 gallons of
moisture.
1. Remove the tank from the base by holding the
handle and lifting straight up (see Figure 2).
2. Twist off the tank cap located on the bottom of the
tank by turning counter clockwise and fill the water
tank with cool, fresh water. Do not fill with warm
water as this may cause leaking.
3. After filling the tank, replace the tank cap by firmly
turning clockwise and then replace the water tank on
the base. The tank will immediately begin to empty
into the base.
4. Plug the power cord into a 120V AC electrical outlet.
P L E A S E R E A D A N D S AV E T H E S E
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
CLEANING/MAINTENANCE
S T O R A G E I N S T R U C T I O N S
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. Keep the cord out of heavy traffic areas. To avoid fire
hazard, NEVER put the cord under rugs or near heat
registers.
4. DO NOT place humidifier near heat sources such as
stoves, radiators, and heaters. DO locate your humidifier
on an inside wall near an electrical outlet. The
humidifier should be at least 4 inches (10 cm) away
from the wall for best results.
5. NEVER place humidifier in an area where it is accessible
to children. NEVER use humidifier in a closed room,
particularly where a child may be sleeping, resting, or
playing (a closed room may result in excessive
humidity).
6. WARNING: Do not attempt to refill humidifier
without first unplugging the unit from its electrical
outlet. Failure to heed this warning may cause
personal injury. Be sure to unplug the unit by pulling
on the plug and not the cord.
7. Never place anything over moisture outlet when the
unit is running.
8. NEVER drop or insert any object into any openings.
9. DO NOT operate any appliance with a damaged cord
or plug, after the appliance malfunctions, or if it has
been dropped or damaged in any manner. Return
appliance to manufacturer for examination, electrical
or mechanical adjustment, or repair.
10.Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
11.DO NOT use outdoors.
12.Always place humidifier on a firm, flat, level surface.
A waterproof mat or pad is recommended for use
under the humidifier. NEVER place it on a rug or
carpet, or on a finished floor that may be damaged
by exposure to water or moisture.
13.DO NOT allow the Moisture Outlet to directly face the
wall. Moisture could cause damage, particularly to
wall paper.
14.Humidifier should be unplugged when not in use.
15.NEVER tilt, move, or attempt to empty unit while it is
operating. Shut off and unplug before removing the
water tank and moving the unit.
16.This humidifier requires daily and weekly
maintenance to operate appropriately. Refer to daily
and weekly cleaning procedures. Use only cleaners
and additives recommended by the manufacturer.
17.NEVER use detergents, gasoline, glass cleaner,
furniture polish, paint thinner, or other household
solvents to clean any part of the humidifier.
18.Excessive humidity in a room can cause water
condensation on windows and some furniture. If this
happens, turn the humidifier OFF.
19.Do not use humidifier in an area where humidity
level is in excess of 50%. Use a hygrometer, available
at your local retailer or through the manufacturer, to
measure the humidity.
trapped on your filter. At this point, you should replace
your filter. It is important to change your filter as indicated
to obtain stated performance level.
To replace the filter, follow the steps below.
1. Push the 1Touch
®
(MODE/OFF) button for 2 seconds
to turn the unit OFF and disconnect from the electrical
outlet.
2. Remove the tank and main housing to access the
base tray (see Figures 1 and 2).
3. Discard the old filter and follow weekly cleaning
instructions.
4. Insert a new filter into the filter support in the base
(Figure 1).
5. Replace the main housing and then the tank.
6. Repeat Operating Instruction steps.
It will take about 30 minutes for the humidifier to reach
maximum output.
You can purchase replacement filters (model HWF62) by
calling 1-800-546-5637 or by visiting
www.holmesproducts.com.
CLEANING AND MAINTENANCE INSTRUCTIONS
Humidifiers provide comfort by adding moisture to dry
indoor air. To get the most of the benefit from the
humidifier and avoid product failure, follow all
maintenance instructions carefully. If the recommended
care and maintenance guidelines are not followed, micro-
organisms may be able to grow in the water within the
humidifier.
DAILY MAINTENANCE
1. Before cleaning, be sure the humidifier is OFF and
disconnected from the electrical outlet.
2. Lift off the tank and the housing of the humidifier.
Remove filter and place in sink or tub as the filter
will release water when not in the humidifier.
3. Carry the base and the tank to the sink, then drain
and rinse the base and tank thoroughly to remove
any sediment and dirt. Wipe clean and dry with a
clean soft cloth or paper towel. (DO NOT use metal
cleaning utensils or abrasive cleaners)
4. Put the filter back in the filter supports, replace the
housing, then refill the tank with cool tap water as
instructed in filling the water tank instructions.
WEEKLY MAINTENANCE
To Remove Scale:
1. Repeat steps 1-3 above.
2. Clean the base by partially filling the base with one
8-oz cup of undiluted white vinegar, or by using
Cleanse Clean
®
Solution (Model S1710) by the
manufacturer. Let solution stand 20 minutes, clean all
interior surfaces with a soft brush.
3. Dampen a cloth with undiluted white vinegar and
wipe out entire base to remove scale.
4. Rinse with clean warm water to remove scale and the
white vinegar solution before beginning to disinfect
the tank.
To Disinfect Humidifier Base and Tank:
1. Fill tank with 1/2 teaspoon of chlorine bleach and
1/2 gallon of water.
2. Let the solution stand for 20 minutes, swishing every
few minutes. Wet all surfaces.
3. Empty the tank after 20 minutes, and rinse well with
water until the bleach smell is gone. Dry with a clean
cloth or paper towel.
4. Refill the water tank with cool water; replace the
housing and the water tank. Repeat ALL Operating
Instructions.
STORAGE INSTRUCTIONS
If your humidifier will not be in use for two days or more,
or at the end of the season follow these instructions.
1. Clean, rinse and thoroughly dry the humidifier as
directed in the weekly maintenance section. DO NOT
leave any water inside the base or tray.
2. Remove the tank cap. Do not store with the tank cap
in place.
3. Place the humidifier in the original carton and store
in a cool, dry place.
4. Always clean the humidifier before the next season
begins.
5. Order a replacement filter to start the next season.
OPERATING INSTRUCTIONS
Your humidifier is equipped with a technologically advanced
1Touch
®
Electronic Humidistat. You can set the humidifier to run
continuously in manual mode or set the 1Touch
®
Electronic
Humidistat to your desired humidity setting. The 1Touch
®
Electronic Humidistat will automatically turn the humidifier ON
or OFF, depending on the preset comfort level. The comfort level
ranges between 35% and 55% relative humidity.
Manual Mode Instructions
1. Plug the humidifier into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button once for
the HI manual setting. (See Figure 2.)
3. Press the button again for the LO manual setting.
(See Figure 2.)
4. To stop the unit, press and hold the MODE/OFF button
for two seconds, or keep pressing the button until all
the humidity indicators are OFF.
NOTE: In Manual Mode, only the LO or HI power light will
be lit.
1TOUCH
®
HUMIDISTAT INSTRUCTIONS
To take advantage of the 1Touch
®
Electronic Humidistat,
press the MODE/OFF button until the speed is set in either
the HIGH or LOW setting, and the Desired Humidity is set.
When the humidity level rises above the set humidity, the
humidifier will stop. When the humidity level drops below
the set humidity, the humidifier will turn on automatically.
NOTE: When the 1Touch
®
Electronic Humidistat is set,
either the HI or LO power light and the percent humidity
light will remain lit during operation. (See Figure 2.)
NOTE: Allow up to 30 minutes for the filter to fully absorb
water and for the unit to produce moisture.
NOTE: The 1Touch
®
Humidifier has memory. This means
that when you turn the unit back on, it will be at the last
setting the humidifier was set at.
If you do not plan to use the humidifier for two or more
days, make sure any residual water is drained from the
water tank, base and wick filter to prevent algae or bacteria
growth.
REPLACING THE FILTER
Through normal use, waterborne minerals and sediment
become trapped in the wick filter. The harder your water,
the greater the amount of minerals in the water, and the
more often you will need to change your filter.
You will be able to monitor the life of the filter in your
humidifier by checking the FilterCheck
®
Indicator. When the
unit is off, the FilterCheck
®
Indicator will read in the OFF
position.
NOTE: After 60 minutes of
use, FilterCheck
®
Indicator
(refer to Figure 3 for close-
up of indicator) will move
from the OFF position and
indicate your filter condition.
A brand new filter will
register in the section
reading GOOD filter. After
frequent use of your humidifier, the FilterCheck
®
Indicator
will let you know when the filter needs to be changed.
When the needle is in the CHANGE section, this means the
proper amount of moisture is not getting into your air due
to the excessive minerals and sediment that have become
P L E A S E R E A D A N D S AV E T H E S E
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
F E AT U R E S - O P E R AT I O N S
Figure 1
A. Circular Filter
Supports
B. Circular Wick
Filter
C. Humidifier
Base
B
C
A
Figure 2
A
B
C
D
E
A.Tank Handle
B.Humidifier Tank
C. Main Housing
D.1Touch
®
with
ClearView
Humidistat
E. Humidifier Base
F. FilterCheck
®
Indicator
G.1Touch
®
Control Panel
F
M
o
d
e
/
O
f
f
G
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
Figure 3
HM1297-U_08EM1.qxd:9100030005230 5/8/08 4:50 PM Page 2