Filter
Top Products
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
FEATURES - OPERATIONS
Thank you for purchasing this Holmes
®
product. We
understand the value of quality and are committed to
making superior products that stand the test of time. We
trust this product will exceed your expectations of quality
and reliability. We hope that you enjoy this product and
will consider purchasing another Holmes
®
product in the
future.
To see our full product line or if you have any questions or
comments about this product, please visit our website at:
www.holmesproducts.com.
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. The heater is hot when in use. To avoid burns, DO
NOT let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 ft (0.9 m) from the
front of the heater and keep them away from the
sides and rear.
4. DO NOT run cord under carpeting. DO NOT cover
cord with throw rugs, runners, or the like. Arrange
cord away from traffic area and where it will not be
tripped over.
5. This heater is not intended for use in bathrooms,
laundry areas and similar indoor location. NEVER
locate heater where it may fall into a bathtub or
other water container.
6. Extreme caution is necessary when any heater is
used by, or near children or invalids, and whenever
the heater is left operating and unattended.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and
not the cord.
9. DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
10.DO NOT operate heater with a damaged cord or
plug, or after the heater malfunctions, has been
dropped or damaged in any manner. Return
appliance to manufacturer for examination, electrical
or mechanical adjustment, or repair.
11.A heater has hot and arcing or sparking parts inside.
DO NOT use it in areas where gasoline, paint, or
flammable liquids are used or stored.
12.Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
13.DO NOT use outdoors.
14.To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. DO NOT use on soft surfaces,
like a bed, where openings may become blocked.
15.To disconnect heater, turn controls to OFF, then
remove plug from outlet.
16.Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated
not less than 1875 watts.
17.If the heater will not operate, see specific instructions
on Auto Safety Shut-off.
18.DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
19.Discontinue use if plug or outlet is hot. It is
recommended that the outlet be replaced if plug or
outlet is hot to touch.
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
TECHNICAL SPECIFICATIONS
• Wattage: 1500W (+5% –15%)
• Working voltage: 120V AC/60Hz
AUTO SAFETY SHUT-OFF WITH CERAMIC
CONTROL
This heater is equipped with a patented, technologically
advanced, safety system that requires the user to reset
the heater if there is a potential overheat situation. When
a potential overheat temperature is reached, the system
will automatically shut the heater off. It can only resume
operation when the user resets the unit. For specific reset
instructions please refer to the unit.
Tip-over Shut-off (for HFH111T only):
When the unit is accidentally knocked over, it will shut
off. To reset, simply place the heater in an upright
position on a level surface.
To Reset the Heater (for HFH110 and WF110
only):
1. Turn MODE to OFF.
2. Unplug unit, wait 30 minutes.
3. Plug in again and turn ON.
To Reset the Heater (for HFH111 and HFH111T
only):
If the unit shuts down:
1. Turn MODE to OFF and THERMOSTAT to HI.
2. Unplug unit, wait 30 minutes.
3. Plug in and turn ON.
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Make sure the unit is in the OFF position before
plugging the heater into the outlet.
3. Place heater on firm level surface.
4. Avoid overloading your circuit by not using other
high wattage appliances in the same outlet.
OPERATING INSTRUCTIONS
1. Turn the Selector Control to desired heat setting LO
or HI.
2. For fan-only operation, without any heat output, turn
the Selector Control to the FAN setting.
3. The Power Light will remain lit during operation.
SETTING THE THERMOSTAT
(FOR HFH111 AND HFH111T ONLY)
1. You need to set thermostat on HI to start heater (See
Figure 1). Allow heater to operate and warm up the
room.
2. When the desired temperature/comfort level is
reached, lower the thermostat setting until the
fan/heater stops operating.
3. The control will now automatically maintain the pre-
set temperature level by turning the heater ON and
OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to raise the thermostat setting.
CLEANING/MAINTENANCE
• Always unplug the heater before cleaning.
• Lightly run a vacuum cleaner nozzle over the heater
grill to remove any dust or dirt that may have
accumulated.
• Carefully wipe the heater with a soft, damp cloth.
Please be very cautious near the motor and heating
elements.
• NEVER use abrasive or flammable solvents to clean
the heater.
• After cleaning, be sure to completely dry the heater
with a cloth or towel.
• Store your heater in its original carton in a cool, dry
location.
TROUBLESHOOTING
If your heater fails to operate, unplug
the heater and:
• Make sure the electrical outlet and circuit breaker
are working.
• Check for obstructions. If you find an obstruction,
turn OFF and UNPLUG the heater. Carefully remove
the obstruction and follow the reset instructions.
• Check the thermostat setting; it might be set too low.
Turn the thermostat dial clockwise until the heater
restarts.
• Make sure the Mode Control is in Lo or Hi setting.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
ILLUSTRATIONS
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in
a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
CLEANING/MAINTENANCE
TROUBLESHOOTING/ILLUSTRATIONS
A. Carry Handle (not
shown)
B. Selector Control
C. Power Light
Figure 1
C
B
A
for HFH110 & WF110
Figure 2
for HFH111 & HFH111T
A. Power Light
B. Mode Control
C. Thermostat Control
D. Carry Handle (not
shown)
C
D
B
A
HFH110/111/111T/WF11007EM1.qxd 1/31/07 16:29 Page 2