Filter
Top Products
OPERATION
10
Concordet HP Plus (07–99)
ACCESSORY TOOL SETUP AND
OPERATION (OPTION)
Machine is equipped with accessory tool hookups. The
floor tool accessory enables you to reach areas that
machine is unable to, such as alcoves and corners.
NOTE: Vacuum area before cleaning.
1. Turn main power switch off.
2. Disconnect vacuum hose from recovery dome and
replace with accessory vacuum hose (Figure 18).
FIG. 18
3. Connect solution hose to accessory coupler at
rear of machine (Figure 19).
FIG. 19
4. Connect hoses to accessory tool.
5. Raise brush lift lever and engage lock block.
6. Turn main power, pump and vacuum switches on.
7. Operate accessory tool as normal.
WARNING: Flammable materials or reactive
metals can cause explosion or fire. Do not pick
up.
8. For floor tool cleaning: Begin cleaning at top of
area and work backwards toward machine.
9. Place floor tool so bottom of stainless shoes are
parallel to floor. Squeeze trigger and apply
downward pressure on floor tool head and slowly
pull tool backwards using both hands. Release
trigger 152 mm (6 in) from end of stroke
(Figure 20).
FIG. 20
10. Push floor tool forward over same path with trigger
released when returning for next stroke. Continue
this pull and push method with a 51 to 102 mm (2
to 4 in) overlap of each stroke.
NOTE: For heavily soiled areas, repeat stroke or
change angle of stroke.
DRAINING TANKS
When finished cleaning, the recovery and solution
tanks should be drained and cleaned.
DRAINING RECOVERY TANK
1. Transport machine to nearest floor sink or drain.
2. Turn all switches off.
3. Remove drain hose from holder, position hose
over floor drain and twist off drain hose plug to
drain (Figure 21).
NOTE: If using a bucket to drain machine, use a
separate bucket for filling solution tank. This will
prevent possible solution line clogs.
Home
Find...
Go To..