Filter
Top Products
OPERATION
8
Concordet HP Plus (01–00)
4. Select cleaning method by pressing restorative/
interim cleaning switch (Figure 11).
FIG. 11
Restorative Cleaning Method: The
machine operates at a slower set speed to restore
heavily soiled carpet areas. The restorative
cleaning method must be performed on a regular
basis in order for the interim cleaning method to
be effective.
Interim Cleaning Method: Machine
operates at faster set speed for routine light
cleaning. The interim cleaning method will be
ineffective if the restorative cleaning method is not
performed on a regular basis.
5. Rotate control grips completely forward to begin
cleaning (Figure 12).
WARNING: Flammable materials or reactive
metals can cause explosion or fire. Do not pick
up.
NOTE: Machine travel speed for the cleaning modes
are set speeds.
FIG. 12
6. View brush pressure meter while operating. Meter
should read center of green zone (Figure 13). If
brush height adjustment is required, see
ADJUSTING BRUSH HEIGHT.
FIG. 13
7. To operate machine in reverse, raise brush lever
and pull reverse drive trigger (Figure 14).
FIG. 14
8. To stop cleaning, release control grips. Raise
brush lever and turn off machine.
9. After cleaning carpet, allow 3 to 4 hours for carpet
to dry. Use air movers to reduce drying time.
WHILE OPERATING MACHINE
WARNING: Flammable materials or reactive
metals can cause explosion or fire. Do not pick
up.
1. Periodically check for foam buildup in recovery
tank
(look through clear dome)
. If excessive foam
buildup begins to develop, pour a recommended
foam control solution into recovery tank.
ATTENTION: Do not allow foam or water beyond
“FULL LINE” label, located on standpipe, vacuum
motor damage will result. Vacuum motor damage
due to foam or water is not covered by warranty.
2. Overlap each pass by about 51 mm (2 in).
3. Keep machine within 152–203 mm (6–8 in) of
baseboard.
4. When turning, it may be necessary to turn pump
switch off and raise brush lift lever.
Home
Find...
Go To..