Filter
Top Products
31Heatilator • NDI30, NDI30-SP, NDI35, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-900 Rev. G • 4/11
G. Install the Log Assembly
Log Set Assembly: LOGS-NDI30
Models: NDI30, NDI30-SP
Log #1 (SRV2226-701) Position Log #1 as shown in Figure 2. Note additional placement instructions in Figure 1. Set the
rear log (Log #1) on the log shelf. Position the log against the back of the fi rebox. Center the log notch over the pilot bracket.
Figure 1.
LOG SHELF
Figure 2. Install Log #1
Figure 3. Place Log #2
Figure 4. Log #2
Log #2 (SRV2226-702): Position Log #2 as shown in Figure 3. Refer to Figure 1 and Figure 4 for additional details. Mate
the slot located on the bottom of Log #2 with the log pin located on the right side of the burner. Move the right end of Log
#2 forward until it comes into contact with the grate tine.
GRATE
TINES
LOG PINS
PILOT
BRACKET
GRATE BAR
LOG
NOTCH
FLAT SPOT FOR
LOG #4
FLAT SPOT FOR
LOG #6
FLAT SPOT FOR
LOG #5
FLAT SPOT FOR
LOG #5
FLAT SPOT
FOR LOG #6
LOG
TOUCHES
GRATE TINE
MATE LOG
PIN WITH
LOG SLOT
SLOT
1
2
SRV2226-701
SRV2226-704
SRV2226-703
SRV2226-705
SRV2226-706
SRV2226-702
CAUTION: Logs are fragile, handle with care.