Filter
Top Products
Heatilator • NDI30, NDI30-SP, NDI35, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-900 Rev. G • 4/11 28
E. Installation for Fan (Optional)
On units already installed, removal of decorative front,
surround and gas insert is required.
• Detach fl exible liner from back of unit if insert is installed.
• Remove the four screws on the cover plate (see Figure
10.6).
• Install and wire the blower per instruction shipped with
the blower. Figure 10.5 also shows a wiring diagram.
• Reinstall the cover plate back on the unit. Make sure the
fan does not make contact with the back wall to prevent
noise from vibration.
Figure 10.6
FAN COVER PLATE